Cisco Meraki MS225 Series - User Manual

MS225 Series Installation Guide
About this Guide
This guide provides instruction on how to install and configure your MS225 series switch. This guide also provides
mounting instructions and limited troubleshooting procedures. For more switch installation guides, refer to the
switch installation guides section on our documentation website.
Model number Description
MS225-24 Stackable Layer-2 24-port gigabit Ethernet switch with 4 SFP+ interfaces
MS225-24P
Stackable Layer-2 24-port gigabit Ethernet 370W PoE switch with 4 SFP+
interfaces
MS225-48 Stackable Layer-2 48-port gigabit Ethernet switch with 4 SFP+ interfaces
MS225-48LP
Stackable Layer-2 48-port gigabit Ethernet 370W PoE switch with 4 SFP+
interfaces
MS225-48FP
Stackable Layer-2 48-port gigabit Ethernet 740W PoE switch with 4 SFP+
interfaces
Product Overview
Physical Specifications
MS225-24 MS225-24P
MS225-48 MS225-48LP MS225-48FP
1

Summary

Front Panel Components

Factory Reset Button

Ports and Status Indicators

Back Panel Components

Management and Stack Port Status

Safety and Warnings

Pre-install Preparation

Configure Dashboard Network

Steps to add and configure switches in the Meraki dashboard.

Check and Set Firmware

Procedure for upgrading switch firmware before installation.

Installation Instructions

Rack Mounting Procedure

Detailed steps for physically mounting the switch in a rack.

Mounting Hardware and Options

Mounting Hardware Details

Basic Troubleshooting

Bringing your Stack Online

Support and Additional Information

Cisco Meraki MS225 Series Specifications