Cisco Meraki MS225 Series User Manual

Switch Ports Off No link is detected on this port
Solid orange 10/100 Mbps (1 Gbps on SFP+)
Solid green 1 Gbps (10 Gbps on SFP+)
In addition, there is a RESTORE button available on the front panel.
Insert a paperclip if a restore is required.
• A brief, momentary press: To delete a downloaded configuration and reboot.
• Press and hold for more than 10 sec: To force the unit into a full factory restore.
Back Panel Components
Function LED Status Meaning
Management Interface Green Connected, used for easy access to the local status page
Stack Ports Green QSFP stacking cable is connected
Off No link is detected on this port
22-Pin Redundant Power Supply
Connector
N/A RPS2300 can be connected to provide redundant power in case of a failover
Power cords may be ordered separately.
Equipment is to be used only in a restricted access location and installed/operated only by trained service personnel.
RPS2300 Redundant Power Supply (Optional)
The MS225 series supports connecting the Cisco RPS2300 for optional power redundancy. MS225 series models
support failover and reversion to main power once it has been restored. The following Cisco part numbers are
supported:
4

Cisco Meraki MS225 Series Specifications

General

Model	MS225 Series
Series	MS225
Category	Switch
Stacking	Yes, via Meraki Cloud
Power Supply	Internal
Layer	Layer 2
DRAM	512 MB
Operating Temperature	0°C to 40°C
Uplink	4 x SFP+
Management	Cloud Managed
Switching Capacity	176 Gbps
Forwarding Rate	131 Mpps
Total PoE Budget	740W (MS225-48FP)
Dimensions (W x D x H)	17.3 x 10.2 x 1.7 in (440 x 260 x 44 mm)
Ports	24 x GbE or 48 x GbE
Power over Ethernet (PoE)	802.3af/at (PoE/PoE+)