Cisco Meraki MS225 Series User Manual

MS225-24 Series front panel
MS225-48 Series front panel
Back Panel
MS225 Series back panel
Factory Reset Button
If the button is pressed and held for at least five seconds and then released, the switch will reboot and be restored to its
original factory settings by deleting all configuration information stored on the unit.
Ports and Status Indicators
The MS uses LEDs to inform the user of the device's status. When the device powers on, all the Internet LEDs flash
twice. Additional functions are described below, from left to right.
Front Panel Components
Function LED Status Meaning
Power Solid orange Switch is unable to connect to the Meraki cloud
Flashing white Firmware upgrade in process
Solid white Switch is fully operational and connected to the Meraki cloud
Off Switch does not have power
Restore N/A Restore button to clear switch IP and local configuration settings
3

Cisco Meraki MS225 Series Specifications

General

Model	MS225 Series
Series	MS225
Category	Switch
Stacking	Yes, via Meraki Cloud
Power Supply	Internal
Layer	Layer 2
DRAM	512 MB
Operating Temperature	0°C to 40°C
Uplink	4 x SFP+
Management	Cloud Managed
Switching Capacity	176 Gbps
Forwarding Rate	131 Mpps
Total PoE Budget	740W (MS225-48FP)
Dimensions (W x D x H)	17.3 x 10.2 x 1.7 in (440 x 260 x 44 mm)
Ports	24 x GbE or 48 x GbE
Power over Ethernet (PoE)	802.3af/at (PoE/PoE+)