Cisco Meraki MS120 Series

MS120 Series Installation Guide
About this Guide
This guide provides instruction on how to install and configure your MS120 series switch. This guide also provides mounting instructions and limited
troubleshooting procedures. For more switch installation guides, refer to the switch installation guides section on our documentation website.
Model number Description
MS120-24 Layer-2 24-port gigabit Ethernet switch with 4 SFP interfaces
MS120-24P Layer-2 24-port gigabit Ethernet 370W PoE switch with 4 SFP interfaces
MS120-48 Layer-2 48-port gigabit Ethernet switch with 4 SFP interfaces
MS120-48LP Layer-2 48-port gigabit Ethernet 370W PoE switch with 4 SFP interfaces
MS120-48FP Layer-2 48-port gigabit Ethernet 740W PoE switch with 4 SFP interfaces
Product Overview
Physical Specifications
MS120-24 MS120-24P MS120-48 MS120-48LP
MS120-48FP
1Gbe RJ45 24
24
48 48 48
1Gbe SFP 4 4 4 4 4
Dedicated
Mgmt Interface
1 1 1 1
1

Cisco Meraki MS120 Series Specifications

General

Layer	Layer 2
DRAM	512 MB
Power Input	100-240 V AC, 50-60 Hz
Operating Temperature	32°F to 104°F (0°C to 40°C)
Ports	8, 24, or 48 ports
Management	Meraki Cloud Management
Stacking	No
VLAN Support	Yes
QoS	Yes
Power Supply	Internal
Power over Ethernet (PoE)	Optional (PoE or PoE+)

Summary

About this Guide

Product Overview

Physical Specifications

Details the physical characteristics, port configurations, and environmental specs.

Product View and Physical Features

Front Panel

Details the layout and components visible on the front of the switch.

Back Panel

Details the layout and components visible on the back of the switch.

Factory Reset Button

Ports and Status Indicators

Rack Mounting Kit

Safety and Warnings

Pre-install Preparation

Configure your Dashboard Network

Guide to setting up the switch on the Meraki cloud dashboard network.

Check and Set Firmware

Check and Configure Upstream Firewall Settings

Assigning an IP Address

Dynamic Assignment

Details how to assign IP addresses dynamically via DHCP.

Static Assignment

Describes the process of manually configuring static IP addresses.

Static IP via DHCP Reservations

Explains using DHCP reservations for static IP assignment.

Installation Instructions

Basic Troubleshooting

Warranty

Support and Additional Information