Cisco Meraki MS120-24 - User Manual

MS120 Series Installation Guide
About this Guide
This guide provides instruction on how to install and configure your MS120 series switch. This guide also provides mounting instructions and limited
troubleshooting procedures. For more switch installation guides, refer to the switch installation guides section on our documentation website.
Model number Description
MS120-24 Layer-2 24-port gigabit Ethernet switch with 4 SFP interfaces
MS120-24P Layer-2 24-port gigabit Ethernet 370W PoE switch with 4 SFP interfaces
MS120-48 Layer-2 48-port gigabit Ethernet switch with 4 SFP interfaces
MS120-48LP Layer-2 48-port gigabit Ethernet 370W PoE switch with 4 SFP interfaces
MS120-48FP Layer-2 48-port gigabit Ethernet 740W PoE switch with 4 SFP interfaces
Product Overview
Physical Specifications
MS120-24 MS120-24P MS120-48 MS120-48LP
MS120-48FP
1Gbe RJ45 24
24
48 48 48
1Gbe SFP 4 4 4 4 4
Dedicated
Mgmt Interface
1 1 1 1
1

Cisco Meraki MS120-24 Specifications

General

Model	MS120-24
Port Count	24
Power over Ethernet (PoE)	No
Power Supply	Internal
DRAM	512 MB
Input Voltage	100-240 VAC
Layer	Layer 2
Ports	24 x Gigabit Ethernet
Operating Temperature	0°C to 40°C
Management	Cloud Managed
Operating Humidity	5% to 95% (non-condensing)

Summary

Factory Reset Button

Ports and Status Indicators

Safety and Warnings

Pre-install Preparation

Configure your Dashboard Network

Outlines the initial steps for adding a switch to your Meraki dashboard network.

Check and Set Firmware

Check and Configure Upstream Firewall Settings

Assigning an IP Address

Static Assignment

Details manual static IP configuration via the switch's web server.

Static IP via DHCP Reservations

Installation Instructions

Basic Troubleshooting