Cisco Meraki MS225 Series User Manual

Meraki MS225 devices have been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
Additional warranty information can be found on: https://meraki.cisco.com/support#process:warranty
Support and Additional Information
If issues are encountered with device installation or additional help is required, contact Meraki Support by logging in to
dashboard.meraki.com and opening a case by visiting the Get Help section.
For additional information on Meraki hardware and for other installation guides, please refer to
documentation.meraki.com.
15

Cisco Meraki MS225 Series Specifications

General

Model	MS225 Series
Series	MS225
Category	Switch
Stacking	Yes, via Meraki Cloud
Power Supply	Internal
Layer	Layer 2
DRAM	512 MB
Operating Temperature	0°C to 40°C
Uplink	4 x SFP+
Management	Cloud Managed
Switching Capacity	176 Gbps
Forwarding Rate	131 Mpps
Total PoE Budget	740W (MS225-48FP)
Dimensions (W x D x H)	17.3 x 10.2 x 1.7 in (440 x 260 x 44 mm)
Ports	24 x GbE or 48 x GbE
Power over Ethernet (PoE)	802.3af/at (PoE/PoE+)