To Next Page

To Previous Page

Back Panel

MX-95

MX-105

Please note that the serial number is located on the product label at the back panel of the MX95/105.

Reset button

Insert a paper clip if a reset is required.

• A brief, momentary press: To delete a downloaded configuration and reboot.

• Press and hold for more than 10 seconds: To force the unit into a full factory reset.

Mounting Recommendations

When installing the appliance, make sure that there is sufficient space between the rear of the rack and other obstacles to ensure adequate airflow. Ventilation is

from side to side not from front to back. This MX security appliance requires a minimum of 10mm clearance between the venting holes and any obstruction.

Package Contents

In addition to the MX device, the following are provided:

MX95 MX105

Internal 2x 150W Power Supply

Safety and Warnings

Warning: The system must be disconnected from all sources of power and the power cord removed from the power supply module(s)

before accessing, installing, or removing system components.

Caution: The Optical Transceiver product should use UL listed, and Rated Laser Class I, 3.3Vdc.

These operations are to be taken with respect to all local laws. Please take the following into consideration for safe operation: