Cisco NCS 1002 - Page 32

Step 2 show controller coherentDSP R/S/I/P
Displays details of the coherent DSP controller. Verify the transmit and expected TTI strings.
Example:
RP/0/RP0/CPU0:ios# show controll coherentDSP 0/0/0/6
Tue Nov 17 22:57:20.724 UTC
Port : CoherentDSP 0/0/0/6
Controller State : Down
Secondary State : Normal
Derived State : In Service
Loopback mode : None
BER Thresholds : SF = 1.0E-5 SD = 1.0E-7
Performance Monitoring : Enable
Alarm Information:
LOS = 2 LOF = 1 LOM = 2
OOF = 0 OOM = 0 AIS = 0
IAE = 0 BIAE = 0 SF_BER = 0
SD_BER = 0 BDI = 0 TIM = 0
FECMISMATCH = 0 FEC-UNC = 0
Detected Alarms : LOS
OTU TTI Sent
OPERATOR SPECIFIC ASCII : abc
:
OPERATOR SPECIFIC HEX : 616263000000000000000000000000
: 00000000000000000000000000000000
OTU TTI Received
OPERATOR SPECIFIC ASCII : abc
:
OPERATOR SPECIFIC HEX : 616263000000000000000000000000
: 00000000000000000000000000000000
OTU TTI Expected
OPERATOR SPECIFIC ASCII : abc
:
OPERATOR SPECIFIC HEX : 616263000000000000000000000000
: 00000000000000000000000000000000
FEC mode : Soft-Decision 7
Network SRLG values : Not Configured
Step 3 show alarms brief card location R/S/I/P active
Displays details of the alarms in brief. Verify the transmit and expected TTI strings.
Example:
RP/0/RP0/CPU0:ios# show alarms brief card location 0/RP0/CPU0 active
Sat Feb 17 11:45:24.590 UTC
--------------------------------------------------------------------------------
Active Alarms
--------------------------------------------------------------------------------
Location Severity Group Set Time Description
--------------------------------------------------------------------------------
0/0 Minor OTN 02/17/2015 11:44:22 CoherentDSP0/0/0/13 - Section Monitoring Trail Trace
Troubleshooting Guide for Cisco NCS 1002, IOS XR Release 6.3.x
22
General Troubleshooting
Using Trail Trace Identifier