PPM FAIL Alarm
Default Severity: Critical (CR), Service-Affecting (SA)
Logical Objects: PPM
The PPM FAIL alarm is raised on the physical pluggable when a fault is detected in the PPM and it becomes
inaccessible.
Clear the PPM FAIL Alarm
Replace the pluggable.
If the alarm does not get cleared, you need to report a Service-Affecting (SA) problem. Log into the Technical Support
Website at http://www.cisco.com/c/en/us/support/index.html for more information or log into http://www.cisco.com/c/
en/us/support/web/tsd-cisco-worldwide-contacts.html to obtain a directory of toll-free Technical Support numbers for
your country.
PKG-K9SEC-REQ Alarm
Default Severity: Minor (MN)
Logical Objects: Chassis equipment
The PKG-K9SEC-REQ alarm occurs when the encrypted slice is configured without installing the k9sec
package or the macsec_mka_aipc_driver library or if the k9sec package is removed when encrypted slice is
available. The macsec_mka_aipc_driver library is contained in the k9sec package.
Clear the PKG-K9SEC-REQ Alarm
This alarm clears after you install the k9sec package containing the macsec_mka_aipc_driver library.
If the alarm does not get cleared, you need to report a Service-Affecting (SA) problem. Log into the Technical
Support Website at http://www.cisco.com/c/en/us/support/index.html for more information or log into
http://www.cisco.com/c/en/us/support/web/tsd-cisco-worldwide-contacts.html to obtain a directory of toll-free
Technical Support numbers for your country.
PSU FAIL Alarm
Default Severity: Major (MJ), Service-Affecting (SA)
Logical Objects: PSU
The PSU FAIL alarm is raised on the NCS 1002 when one of the power modules fail.
Clear the PSU FAIL Alarm
You must log into the Technical Support Website at http://www.cisco.com/cisco/web/support/index.html for more
information or call Cisco TAC (1 800 553-2447) immediately.
Troubleshooting Guide for Cisco NCS 1002, IOS XR Release 6.3.x
66
Alarm Troubleshooting
PPM FAIL Alarm
To Next Page
Loading...
Need help?
General
