Need help?Do you have a question about the Cisco NCS 5501 and is the answer not in the manual?
General| Product Name | Cisco NCS 5501 |
|---|---|
| Category | Network Router |
| Rack Units | 1 RU |
| Total Number of Ports | 54 |
| DRAM | 16 GB |
| Flash Memory | 64 GB |
| Memory | 16 GB DRAM |
| Forwarding Capacity | Up to 1.2 Tbps |
| Operating System | Cisco IOS XR |
| Switching Capacity | Up to 1.2 Tbps |
| Throughput | Up to 1.2 Tbps |
| Power Supply | Dual AC/DC |
| Storage | 64 GB |
| Operating Temperature | 32°F to 104°F (0°C to 40°C) |
| Humidity | 5% to 85% non-condensing |
Overview of the Cisco NCS 5500 series fixed-port router models.
Outlines the workflow for installing the Cisco NCS 5500 Series fixed-port chassis.
Details essential safety precautions for personnel and equipment during installation.
Lists site preparation requirements and checks before chassis installation.
Lists the necessary tools and equipment for chassis installation.
Illustrates grounding requirements for the building housing the chassis.
Demonstrates personnel preparation with ESD straps before handling the chassis.
Provides instructions for preparing a four-post 19-inch rack for chassis installation.
Details the procedure for mounting the NCS 5500 Series chassis into a four-post rack.
Provides instructions for mounting the NCS 5500 Series chassis into a two-post rack.
Explains how to install air filters on the NCS 5500 Series routers.
Describes critical steps for properly grounding the chassis for safety.
Details the procedure for connecting AC power to the NCS 5500 Series chassis.
Provides instructions on wiring a DC power connector for the chassis.
Details the procedure for connecting DC power to the NCS 5500 Series chassis.
Guidelines for connecting ports using QSFP+, QSFP28, SFP, SFP+, and RJ-45 connectors.
Explains connecting a data terminal to the console port for initial configuration.
Details connecting to the management Ethernet port for out-of-band management.
Guides through assigning an IP address and configuring the router.
Instructions for installing and removing SFP, SFP+, QSFP+, and QSFP28 transceiver modules.
Describes connecting optical interface ports on line cards for network connectivity.
Guidelines for maintaining transceivers and optical cables for optimal performance.
Displays FRUs, product IDs, and serial numbers.
Displays all environment-related router information.
Displays temperature readings and alarm thresholds.
Manages card power states (shutdown/startup).
Displays power usage information for the router.
Displays voltage readings for the router.
Displays the current environment status.
Displays the status of fan trays.
Procedure for replacing fan modules in specified NCS routers.
Instructions for replacing fan modules in NCS 5502 models.
Guides on replacing AC and DC power supply units in NCS chassis.
Environmental operating ranges and physical dimensions for NCS 5501 models.
Specifies required front and rear clearances for airflow and module installation.
Details weight, quantity, and power consumption for NCS series.
Explains the importance of proper airflow direction for the NCS 5000 series router.
Information on supported transceivers, connectors, and cables.
Describes Attention, Status, and Alarm LEDs on the chassis front.
Explains the Status LED for fan tray modules on NCS 5500 series.
Details the OK/FAIL (or Status) LEDs for power supply modules.
To Next Page