Pull on the lever to slide the card part way out of the chassis. Release the lever, hold the front of the card and
pull the card all the way out of the chassis.
3
f) Use one hand to hold the front of the card, place your other hand under the card to support its weight, pull the card
out of the chassis, and set the it on an antistatic surface or inside an antistatic bag.
Step 4 To install a new card, follow these steps:
a) Pull the middle section of the ejector handle toward the end of the handle and rotate the handle away from the front
of the card.
This action opens the lever so that the card can be fully inserted into the slot.
b) Hold the front of the card with one hand and place your other hand under the card to support its weight.
c) Align the back of the card to the guides in the open route processor slot and slide the card all the way into the slot
(see the following figure).
The card stops when its front is about 0.25 inches (0.6 cm) outside the front of the chassis.
Figure 55: Install route processor card into Chassis
Slide the back end of the card into the open route
processor slot.
3Slide the middle handle toward the end of the ejector
lever.
1
Rotate the ejector lever away from the card.2
d) Rotate the lever all the way to the front of the chassis until it locks in place with a click.
Make sure that the other end of the lever engages behind the front of the slot so that the card fully seats onto the
connectors on the midplane.
e) Screw in the two captive screws to secure the card to the chassis. Tighten the screws to 8 in-lb (0.9 N·m) of torque.
f) Attach the following cables to the card:
• Console cable—Attach to the Console port.
• Management cable—Attach to the Management Ethernet port.
Hardware Installation Guide for Cisco NCS 5500 Series Modular Routers
99
Replace Chassis Components
Replace a Route Processor Card
To Next Page
Loading...
Need help?
General
