Enter root-system username:
% Entry must not be null.
Enter root-system username: root
Enter secret:
Use the 'configure' command to modify this configuration.
User Access Verification
Username: root
Password:
RP/0/RP0/CPU0:ios#
Step 3
Enter a new password to use for this router.
The software checks the security strength of your password and rejects your password if it is not considered to be a strong
password. To increase the security strength of your password, make sure that it adheres to the following guidelines:
•
At least eight characters
•
Minimizes or avoids the use of consecutive characters (such as "abcd")
•
Minimizes or avoids repeating characters (such as "aaabbb")
•
Does not contain recognizable words from the dictionary
•
Does not contain proper names
•
Contains both uppercase and lowercase characters
•
Contains numbers as well as letters
Clear text passwords cannot include the dollar sign ($) special character.Note
If a password is trivial (such as a short, easy-to-decipher password), the software will reject your password
configuration. Be sure to configure a strong password as explained in this step. Passwords are case sensitive.
Tip
If you enter a strong password, the software asks you to confirm the password.
Step 4
Enter the same password again.
If you enter the same password, the software accepts the password .
Step 5
Enter the IP address for the management interface.
Step 6
Enter a network mask for the management interface.
Step 7
The software asks if you need to edit the configuration. Enter no to not edit the configuration.
Step 8
The software asks if you need to save the configuration. Enter yes to save the configuration.
Hardware Installation Guide for Cisco NCS 5500 Series Fixed-Port Routers
40
Connect Router to the Network
Creating the Initial Router Configuration
To Next Page
Loading...
Need help?
General
