Cisco Network Assistant User Manual

A-1
Getting Started with Cisco Network Assistant
OL-6194-07
APPENDIX
A
Configuring a Catalyst 4500 Series Switch for
Network Assistant Management
This appendix describes how to configure a Catalyst 4500 series switch for Network Assistant. It also
lists the Network Assistant feature defaults for the switch.
Note For complete information on configuring Network Assistant on the Catalyst 4500 series switch, see the
“Configuring the Catalyst 4500 Series Switch with Cisco Network Assistant” chapter in the
Catalyst 4500 Series Switch Cisco IOS Software Configuration Guide.
Note For complete syntax and usage information for the switch commands used in this chapter, see the
Catalyst
4500 Series Switch Cisco IOS Command Reference and related publications at this location:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/index.htm.
This appendix contains these topics:
• Network Assistant-Related Features and Their Defaults, page A-1
• Configuring Your Switch for Network Assistant, page A-2
Network Assistant-Related Features and Their Defaults
Table A-1 lists the Network Assistant-related configuration parameters on a Catalyst 4500 series switch.
Ta b l e A-1 Network Assistant-Related Configuration on a Catalyst 4500 Series Switch
Feature Default Value Recommended Value
Authentication Disabled Optional
IP address Depends on
community or
discovery option
1
User selectable
IP HTTP port number 80 Optional
2
IP HTTPS port number 443 Optional
3
IP HTTP server Disabled Enabled
4
Cluster run Disabled Enabled
5

Cisco Network Assistant Specifications

General

Brand	Cisco
Model	Network Assistant
Category	Software
Language	English