Cisco Nexus 7010 - Page 6

Send document comments to nexus7k-docfeedback@cisco.com
Contents
vi
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Creating an Initial Switch Configuration 6-3
Setting Up the Management Interface 6-4
Connecting the Supervisor CMP Port 6-5
Connecting an I/O Module 6-5
Connecting or Disconnecting a 1000BASE-T Port 6-8
Connecting a 1000BASE-T Port to the Network 6-8
Disconnecting a 1000BASE-T Port from the Network 6-9
Connecting or Disconnecting an SFP, SFP+, or X2 Port 6-9
Installing a Transceiver 6-10
Removing a Transceiver 6-10
Connecting a Fiber-Optic Cable to a Transceiver 6-11
Disconnecting a Fiber-Optic Cable from a Transceiver 6-11
Maintaining Transceivers and Fiber-Optic Cables 6-12
CHAPTER 7 Managing the Switch Hardware 7-1
Displaying the Switch Hardware Inventory 7-1
Displaying the Switch Serial Number 7-7
Displaying Power Usage Information 7-9
Power Supply Configuration Modes 7-10
Power Supply Configuration Overview 7-10
Configuring the Power Supply Mode 7-12
Power Supply Configuration Guidelines 7-13
Information About Modules 7-17
Supervisor Modules 7-17
I/O Modules 7-19
Fabric Modules 7-19
Verifying the Status of a Module 7-19
Checking the State of a Module 7-20
Connecting to a Module 7-21
Accessing an I/O Module Through the Console 7-22
Shutting Down Modules 7-23
Shutting Down a Supervisor or I/O Module 7-23
Shutting Down a Fabric Module 7-23
Information About Module Temperature 7-23
Overview of Module Temperatures 7-23
Displaying the Module Temperature 7-24
Displaying Environment Information 7-25
Reloading Modules 7-28