Connecting the USB LTE Dongle to the Terminal Server
This section provides the necessary steps to establish a successful connection between the USB LTE Dongle
and the Terminal server.
SUMMARY STEPS
1. Pick up the R-Brackets (700-121611-01) Place and fix the bracket at an appropriate location on the rack
using two screws.
2. Tighten the screw, the recommended torque is 10-12 in-lb.
3. Assemble dongle, USB, cable and antenna together in advance.
4. Pick up the wall-mounting bracket (700-121609-01) and 2 SCREWS (48-0580-01).
5. Align and fasten the screws.
6. Plug the USB cable to the USB port on the chassis to complete the mounting procedure.
DETAILED STEPS
Step 1 Pick up the R-Brackets (700-121611-01) Place and fix the bracket at an appropriate location on the rack using two screws.
Step 2 Tighten the screw, the recommended torque is 10-12 in-lb.
Step 3 Assemble dongle, USB, cable and antenna together in advance.
Step 4 Pick up the wall-mounting bracket (700-121609-01) and 2 SCREWS (48-0580-01).
Step 5 Align and fasten the screws.
Step 6 Plug the USB cable to the USB port on the chassis to complete the mounting procedure.
Install and Remove Small Form-Factor Pluggable Modules and Field Replaceable Units
6
Install and Remove Small Form-Factor Pluggable Modules and Field Replaceable Units
Connecting the USB LTE Dongle to the Terminal Server
To Previous Page
Loading...
