12 Cisco Small Business NSS324 and NSS326 Smart Storage
STEP 3 Connect the supplied power cord to the Power port on the back of
the chassis.
STEP 4 Plug the other end of the power cord into a battery backed-up
outlet on the UPS, or a standard power outlet if a UPS is not being
used.
STEP 5 To start the NAS, press and release the Power button on the front
panel.
Listen for one beep. Wait for one to two minutes until the device
beeps another time.
The device has started successfully. The power light turns solid
green when the NAS is ready to use.
Verifying the Hardware Installation
To verify the hardware installation, complete the following tasks:
• Check the cable connections.
• Check the LED states, as described in Getting to Know the NSS324
and NSS326, page 3.
If you encounter problems, consider the following tips:
• If the NAS does not recognize the disk drives, possible causes and
solutions are:
– Confirm the disk drive is supported by Cisco. See the Cisco
approved vendor list at www.cisco.com/go/smallbizsmartstorage.
– Disk tray is installed incorrectly. Try removing and reseating the
disk tray.
– Power the device off, then back on to recognize the disk drives.
NOTE If you need help resolving a problem, visit the Cisco Small Business
Support Community at www.cisco.com/go/smallbizsupport. For
technical documentation and other links, see Where to Go From Here,
page 34.
To Next Page
Loading...
