Cisco ONS 15454 M12 - Page 12

NoneSecurity Level
Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do
not view directly with optical instruments. Viewing the laser output with certain optical instruments
(for example, eye loupes, magnifiers, and microscopes) within a distance of 100 mm may pose an eye
hazard. Statement 1056
Warning
Procedure
Step 1 Using an inspection microscope, inspect each fiber connector for dirt, cracks, or scratches.
Step 2 Replace any damaged fiber connectors.
Replace all dust caps whenever the equipment is unused for 30 minutes or more.
Note
Step 3 Complete the DLP-G262 Clean Fiber Connectors with CLETOP, on page 13 as necessary.
Step 4 Complete the DLP-G263 Clean the Fiber Adapters, on page 13 as necessary.
To clean multi-fiber optic connectors, complete the DLP-G261 Clean Multi Fiber-Optic Cable
Connectors, on page 12 as necessary.
Note
Stop. You have completed this procedure.
DLP-G261 Clean Multi Fiber-Optic Cable Connectors
This task cleans the multi fiber optic connectorsPurpose
Cleaning Cartridge for multi fiber optic connectorsTools/Equipment
NonePrerequisite Procedures
RequiredRequired/As Needed
OnsiteOnsite/Remote
NoneSecurity Level
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams
or view directly with optical instruments. Statement 1051
Warning
Procedure
Step 1 Remove the protective cap on the optical fiber cable connector.
Maintaining the ONS 15454 M12 (ANSI and ETSI), ONS 15454 M2 and ONS 15454 M6 Shelf
12
Maintaining the ONS 15454 M12 (ANSI and ETSI), ONS 15454 M2 and ONS 15454 M6 Shelf
DLP-G261 Clean Multi Fiber-Optic Cable Connectors