Cisco PLE300 - Security for Additional Adapter

Chapter 3
Advanced Security
7
Powerline AV Network Adapter
On Adapter 1 or 2, press and hold the HomePlug Simple 3.
Connect button for two seconds. Then release the
button. The Power LED starts flashing.
After the Network Password is configured, Adapter 3 4.
will restart, and the Power and Powerline LEDs
light up.
(If the Powerline LEDs do not light up, try again; repeat
steps 1-3.)
Power, Ethernet, and Powerline LEDs are Lit
NOTE: The Powerline LED indicates that
the connection between Adapter 3 and your
powerline network has been established.
Repeat steps 1-4 to add additional Adapters, one at a 5.
time.
Congratulations! Security has been configured for the
additional Powerline AV Adapter(s).