Cisco PTZ 4K Camera - Connect Precision 60 to Codec Pro

Cisco Quad Camera, Precision 60, SpeakerTrack 60, PTZ-12, and PTZ 4K Camera
D15296.12 Cisco Quad Camera, Precision 60, SpeakerTrack 60, PTZ-12, and PTZ 4K Camera JULY 2021.
Copyright © 2021 Cisco Systems, Inc. All rights reserved.
17
Camera guide
Connect Precision 60 to Codec Pro
• Connect the video cable (HDMI) between the camera and codec.
Codec: Always use Connector 1 (HDMI input) for the main camera.
Camera: Connect to the HDMI output.
• If you use a coaxial cable for video, you will need a BNC to
HD-BNC cable or a BNC to HD-BNC adapter to connect the
Precision 60 (BNC) to the Codec Pro (HD-BNC).
• Connect the camera control cable (Ethernet) between the camera
control ports on the camera and codec.
Codec: The connector is marked with the camera control symbol.
Camera: Connect to the Ethernet port.
• Connect the power adapter to the camera and connect to power.
• Connect other codec cables as described in theCisco Webex
Room Kit Pro Precision 60 installation guide.
Power
(100-240 V
AC
, 50/60 Hz)
Power
adapter
Always use the provided power cable
and adapter.
RJ45 HDMI
Contents
Introduction
Physical interface
Connecting to a codec
Appendix
Factory reset
Connecting to a codec