Cisco Router Cisco IOS XR - Page 129

4-43
Cisco IOS XR Getting Started Guide
OL-10957-02
Chapter 4 Configuring General Router Features
Configuring the Management Ethernet Interface
Examples
In the following example, the Management Ethernet interface on the RP in slot RP1 is configured with
an IP address:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# interface MgmtEth0/RP1/CPU0/0
RP/0/RP0/CPU0:router(config-if)# ipv4 address 10.1.1.1 255.255.255.0
RP/0/RP0/CPU0:router(config-if)# no shutdown
RP/0/RP0/CPU0:router(config-if)# commit
RP/0/RP0/CPU0:router(config-if)# end
RP/0/RP0/CPU0:router#
RP/0/RP0/CPU0:router# show interfaces mgmtEth 0/RP0/CPU0/0
MgmtEth0/RP0/CPU0/0 is up, line protocol is up
Hardware is Management Ethernet, address is 0011.93ef.e8ea (bia 0011.93ef.e8e)
Description: Connected to Lab LAN
Internet address is 10.1.1.1/24
MTU 1514 bytes, BW 100000 Kbit
reliability 255/255, txload Unknown, rxload Unknown
Encapsulation ARPA, loopback not set,
ARP type ARPA, ARP timeout 04:00:00
Last clearing of "show interface" counters never
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
375087 packets input, 22715308 bytes, 87 total input drops
0 drops for unrecognized upper-level protocol
Received 297320 broadcast packets, 0 multicast packets
0 runts, 0 giants, 0 throttles, 0 parity
48 input errors, 43 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
89311 packets output, 6176363 bytes, 0 total output drops
Output 53 broadcast packets, 0 multicast packets
0 output errors, 0 underruns, 0 applique, 0 resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Step 8
end
Example:
RP/0/RP0/CPU0:router(config)# end
Ends the configuration session and returns to EXEC
mode.
Step 9
show interfaces MgmtEth rack / slot /CPU0/ port
Example:
RP/0/RP0/CPU0:router# show interfaces
MgmtEth0/RP0/CPU0/0
Displays the interface details to verify the settings.
Command or Action Purpose