Cisco Router Cisco IOS XR - Page 217

Index
IN-5
Cisco IOS XR Getting Started Guide
OL-10957-02
M
Management Ethernet interface
configuring
4-39
displaying 4-40
DRP PLIM illustration 4-5
establishing a connection through 4-10
name syntax 4-39
PRP-2 illustration 4-5
RP for 16-slot LCC illustration 4-3
RP for 4-slot and 8-slot LCCs, illustration 4-4
maximum external-sa command 5-23
maximum group-mappings autorp command 5-23
maximum groups command
IGMP configuration mode
5-23
IGMP interface mode 5-23
maximum interfaces command 5-18
maximum path ipv4 command 5-16
maximum path ipv6 command 5-16
maximum paths command
OSPF
5-18
maximum-paths command
BGP
5-20
IS-IS 5-17
maximum paths command, OSPF 5-18
maximum peer-external-sa command 5-23
maximum-prefix command 5-20
maximum-redistributed-prefixes command (IS-IS) 5-17
maximum redistributed-prefixes command (OSPF) 5-18
maximum register-states command 5-23
maximum route-interfaces command 5-23
maximum routes command 5-23
memory
displaying system memory
7-10
low memory warnings 7-9
management 5-16
removing configurations 7-11
mode
administration configuration
4-19
administration EXEC 4-19
configuration submodes 4-20
EXEC 4-19
global configuration 4-20
interface configuration 4-20
ROM monitor 4-21
router configuration 4-20
router submode configuration 4-21
modem connection
DRP PLIM illustration
4-5
PRP-2 illustration 1-12, 4-5
RP for 16-slot LCC illustration 1-10, 4-3
RP for 4-slot and 8-slot LCCs, illustration 1-11, 4-4
module
number displayed in prompt
4-12
More prompt 6-7
MPLS
configuration limits
5-23
mpls traffic-eng maximum tunnels command 5-24
multicast, configuration limits 5-23
multishelf system
four-FCC system illustration
1-5
hardware requirements 3-2
overview 1-2
restrictions 3-2
single-FCC system illustration 1-3
software requirements 2-1, 3-1
two-FCC system illustration 1-4
N
name, router
configuring
4-38
displayed in prompt 4-12
named SDR 4-1
netadmin user group 4-14
network connection, overview 4-3
no, command form 6-5
no debug command 7-7