Chapter 4
Advanced Configuration
9
10/100 16-Port VPN Router
The Summary table shows the settings of the selected
port, including Type, Interface, Link Status, Port Activity,
Priority, Speed Status, Duplex Status, Auto negotiation,
and VLAN.
Port 1 Information
For the selected port, the statistics table shows this
information: number of packets received, number of
packet bytes received, number of packets transmitted,
number of packet bytes transmitted, and number of
packet errors.
To update the on-screen information, click Refresh. To
exit this screen, click Close.
Network Setting Status
LAN IP It shows the current LAN IP address of the Router,
as seen by internal users on the network, and it hyperlinks
to the LAN Setting section on the Network screen of the
Setup tab.
WAN IP This shows the current WAN IP addresses of
the Router, as seen by external users on the Internet
and hyperlinks to the WAN Setting section on the Setup
> Network screen. By default, the Router provides two
WAN ports. On the Setup > Network screen, you can set up
additional WAN ports.
If the port is set to Obtain an IP automatically, two buttons,
Release and Renew, will be available. Click Release to
release the IP address, and click Renew to update the
DHCP Lease Time or get a new IP address. If the WAN
port is set to PPPoE or PPTP, two buttons, Connect and
Disconnect, will be available.
DMZ IP This shows the DMZ IP address, as seen by
external users on the Internet and hyperlinks to the DMZ
Setting section on the Setup > Network screen.
Mode It shows the Router’s Working Mode (Gateway or
Router), and it hyperlinks to the Dynamic Routing section
on the Setup > Advanced Routing screen.
DNS It shows all DNS server IP addresses and hyperlinks
to the WAN Connection Type settings on the Setup >
Network screen.
Bandwidth Management It shows the Bandwidth
Management settings of the Router’s WAN port(s) and
hyperlinks to the System Management > Bandwidth
Management screen.
DDNS It shows the DDNS settings of the Router’s WAN
port(s) and hyperlinks to the Setup > DDNS screen.
DMZ Host It shows the DMZ private IP address and
hyperlinks to the Setup > DMZ Host screen. The default is
Disabled.
Firewall Setting Status
SPI (Stateful Packet Inspection) It shows the status
(On/Off) of the SPI setting and hyperlinks to the Firewall >
General screen.
DoS (Denial of Service) It shows the status (On/Off) of
the DoS setting and hyperlinks to the Firewall > General
screen.
Block WAN Request It shows the status (On/Off) of
the Block WAN Request setting and hyperlinks to the
Firewall > General screen.
VPN Setting Status
VPN Summary It hyperlinks to the VPN > Summary
screen.
Tunnel(s) Used It shows the number of VPN tunnels
used.
Tunnel(s) Available It shows the number of VPN tunnels
available.
Current Connected (The Group Name of GroupVPN1)
users It shows the number of users. (If the GroupVPN
feature is disabled, the message, “No Group VPN was
defined”, is displayed.)
Current Connected (The Group Name of GroupVPN2)
users It shows the number of users.
PPTP Server It shows the status of the PPTP Server
feature.
Log Setting Status
It hyperlinks to the Log > System Log screen of the Log
tab.
If you have not set up the e-mail server on the Log tab,
the message, “E-mail cannot be sent because you have
To Next Page
Loading...
