Cisco RV016 - Setup > DMZ Host; DMZ Host; Setup > Forwarding; Forwarding

Chapter 4
Advanced Configuration
15
10/100 16-Port VPN Router
Daylight Saving To use the daylight saving feature, select
Enabled. Enter the Month and Day of the start date, and
then enter the Month and Day of the end date.
NTP Server Enter the URL or IP address of the NTP server.
The default is time.nist.gov.
Manual
Setup > Time > Manual
Hours, Minutes, Seconds Enter the time.
Month, Day, Year Enter the date.
Click Save Settings to save your changes, or click Cancel
Changes to undo them.
Setup > DMZ Host
The DMZ (Demilitarized Zone) Host feature allows one
local user to be exposed to the Internet for use of a
special-purpose service such as Internet gaming or
videoconferencing. Although Port Range Forwarding can
only forward ten ranges of ports maximum, DMZ hosting
forwards all the ports to one computer at the same time.
Setup > DMZ Host
DMZ Host
DMZ Private IP Address Enter the local IP address of
the computer you want to expose. The default value of 0
deactivates the DMZ Host.
Click Save Settings to save your change, or click Cancel
Changes to undo it.
Setup > Forwarding
The Forwarding screen allows you to set up port range
forwarding and port triggering applications. Port range
forwarding can be used to set up public services or other
specialized Internet applications on your network, while
port triggering can be used to set up triggered ranges and
forwarded ranges for Internet applications.
Setup > Forwarding
Forwarding
Port Range Forwarding
Port forwarding can be used to set up public services on
your network. When users from the Internet make certain
requests on your network, the Router can forward those
requests to computers equipped to handle the requests.
If, for example, you set the port number 80 (HTTP) to be
forwarded to IP address 192.168.1.2, then all HTTP requests
from outside users will be forwarded to 192.168.1.2.
NOTE: You must disable the Router’s DHCP
function to use port forwarding.
You may use this function to establish a web server or FTP
server via an IP gateway. Make sure that you enter a valid
IP address. (You may need to establish a static IP address
in order to properly run an Internet server.) For added
security, Internet users will be able to communicate with
the server, but they will not actually be connected. The
packets will simply be forwarded through the Router.
Service Select the Service you want.
IP Address Enter the IP address of the server that you
want the Internet users to access.