Cisco RV130 Quick Guide

Step 3. A confirmation window appears. Click Yes to continue.
Step 4. After the reboot is completed, login with the default credentials. The default
username is cisco and the default password is cisco.
Hardware Reset
Step 1. Press the Reset button located at the back of the device with a pin for approximately
15 seconds or until the power light on the front of the device starts flashing.
The Router reloads and is set to the default configuration settings.
Step 2. Login with the default credentials. The default username is cisco and the default
password is cisco.
Rebooting the Device
The router can be reset to the factory default settings through either the web configuration
utility or the power button on the back of the router.
Reboot with the use of the Web Configuration Utility

Cisco RV130 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.1D, IEEE 802.1p, IEEE 802.1Q, IEEE 802.1w, IEEE 802.3, IEEE 802.3u
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
Dual-band	No
Ethernet LAN (RJ-45) ports	4
Supported network protocols	PPPoE, PPTP, L2TP, DNS, IGMP, RSTP, NAT, PAT, SIP, ALG
Web-based management	-
Security algorithms	AES
Product color	Black
Certification	FCC, CE, IC
Input current	2 A
Output voltage	12 V
Power source type	DC
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Weight	- g