Cisco RV180W - User Manual

WAN Configuration on RV180 AND RV180W
Objectives
This document explains how to configure the IPv4 WAN(Internet) for use with a Static IP on
the RV180 and RV180W.
Static IP is for use with internet providers who assign the user a permanent IP address.
Using a static IP is less secure because the IP address is always the same, however it is
more dependable for some services. Such as Voice over Internet Protocol(VOIP) or if you
using the computer for a server.
Applicable Devices
• RV180
• RV180W
Steps of Procedure
Step 1. Use the router configuration utility to choose Networking > WAN(Internet) > IPv4
WAN (internet). The IPv4 WAN (internet) page opens.
Step 2. Choose the Static IP option from the Internet Connection Type drop-down menu.

Cisco RV180W Specifications

General

Device Type	Wireless-N VPN Router
WAN Ports	1
LAN Ports	4
Wireless Standard	802.11n
Wireless Speed	Up to 300 Mbps
VPN Support	Yes
Firewall	Yes
Power Supply	12V DC
VPN	IPsec

Summary

WAN Configuration Procedures

Objectives and Applicable Devices

Overview of the document's goals, supported devices, and introductory context.

Static IP Configuration

Steps to configure the router for a Static IP internet connection, including IP settings.

PPPoE Configuration

Guide to setting up a PPPoE internet connection, including profile and MTU settings.

PPTP Configuration

Steps to configure a PPTP internet connection, covering authentication and IP details.

L2 TP Configuration

Instructions for configuring an L2TP internet connection, including authentication and IP details.