EasyManuals Logo
Home>Cisco>Network Router>RV160

Cisco RV160 User Manual

Cisco RV160
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Cisco RV160 Router Quick Start Guide 3
Mount the router with the front panel facing upward. Make sure to mount
the router low enough so that you can see the LEDs.
Make sure that the power supply rests on a horizontal surface such as
the floor or a table. If the power supply is not supported, the strain on
the power adapter cable could cause it to disconnect from the router.
Do not install the router or its power supply next to a heat source of any
kind, including heating vents.
You can mount the router on a hollow wall or a wall stud. To mount the
router, follow these steps:
STEP 1 Position the router on the wall to determine where to attach the two
mounting screws. Drill two pilot holes at approximately 109 mm
apart.
STEP 2 Insert a screw into each hole, leaving a gap between the surface
and the base of the screw head of 1 to 1.2 mm.
STEP 3 Place the router wall-mount slots over the screws and slide the
router down until the screws fit snugly into the wall-mount slots.
WARNING Insecure mounting might damage the router or cause injury.
Cisco is not responsible for damages incurred due to insecure
wall-mounting.
WARNING For safety reasons, please ensure that the heat dissipation
holes are facing sideways.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco RV160 and is the answer not in the manual?

Cisco RV160 Specifications

General IconGeneral
DSL WAN-
Ethernet WANYes
Throughput0.6 Gbit/s
Cabling technology10/100/1000Base-T(X)
Networking standardsIEEE 802.1x
Ethernet LAN data rates10, 100, 1000 Mbit/s
Ethernet interface typeGigabit Ethernet
Combo SFP ports quantity1
Ethernet LAN (RJ-45) ports4
Mobile network generationNot supported
Security algorithmsIPSec
VPN tunnels quantity10
Routing protocolsRIP-1, RIP-2, RIPng
Product colorBlack, Grey
Country of originChina
Power source typeDC
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 40 °C
Storage relative humidity (H-H)5 - 90 %
Operating relative humidity (H-H)10 - 85 %
Processor cores2
Quantity per pack1 pc(s)
Harmonized System (HS) code85176990
Package depth288.798 mm
Package width249.936 mm
Package height106.934 mm
Package weight1224.7 g
Weight and Dimensions IconWeight and Dimensions
Depth199.898 mm
Width150.114 mm
Height29.972 mm
Weight589.95 g

Related product manuals