EasyManuals Logo

Cisco SD208T-NA Hardware Installation Guide

Cisco SD208T-NA
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #53 background imageLoading...
Page #53 background image
CHAPTER
4-1
Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide
OL-13478-03
4
Installing the Internet Streamer CDS Software
and Initially Configuring a CDE
This chapter describes the initial installation of the Cisco Internet Streamer CDS Release 2.0-2.1
software application suite, and the initial configuration of the CDE. This chapter contains the following
sections:
Before You Begin, page 4-1
Running the BIOS Setup Utility, page 4-2
Installing the Software, page 4-13
Initially Configuring a CDE, page 4-14
Verifying the CDSM, page 4-15
Before You Begin
You need the following to perform the initial installation and configuration of the CDS:
CDE100 or CDE200
USB CD-ROM drive (for CDE200 only [provided])
Internal IDE compact flash drive (pre-installed)
Terminal server connection with the following parameters:
9600 baud
8 bits
No parity
Redirection After BIOS POST is off in CDE BIOS setup
Console redirection enabled for COM1
CDS image CD
Network connection
Note On the CDE200, use the USB port to connect the USB CD-ROM drive. After the initial installation,
remove the USB CD-ROM drive. The internal IDE compact flash drive becomes the boot drive for
subsequent operations.

Table of Contents

Other manuals for Cisco SD208T-NA

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SD208T-NA and is the answer not in the manual?

Cisco SD208T-NA Specifications

General IconGeneral
BrandCisco
ModelSD208T-NA
CategorySwitch
LanguageEnglish

Related product manuals