Cisco 220 Series Smart Plus Switches Quick Start Guide 11
reconnect the devices for them to discover their new IP
addresses from the DHCP server.
NOTE Details on how to change the IP address on your computer
depend upon the type of architecture and operating system that
you are using. Use your computers local Help and Support
functionality and search for “IP Addressing.”
STEP 5 Open a web browser window. If you are prompted to install an
Active-X plug-in when connecting to the device, follow the
prompts to accept the plug-in.
STEP 6 Enter the switch IP address in the address bar and press Enter. For
example, http://192.168.1.254.
STEP 7 When the login page appears, choose the language that you prefer
to use in the web-based interface and enter the username and
password.
The default username is cisco. The default password is cisco.
Usernames and passwords are both case sensitive.
STEP 8 Click Log In.
If this is the first time that you have logged on with the default
username and password, the Change Password page opens.
STEP 9 Enter a new password and confirm the password.
NOTE Password complexity is enabled by default. The password
must comply with the default complexity rules or it can be disabled
temporarily by selecting Disable Password Strength
Enforcement.
STEP10 Click Apply.
CAUTION Make sure that any configuration changes made are saved
before exiting from the web-based interface by clicking on
the Save icon. Exiting before you save your configuration will
result in all changes being lost.
The Getting Started page opens. You are now ready to configure
the switch. Refer to the
Cisco 220 Series Smart Plus Switches
Administration Guide
or see the help pages for further information.
To Next Page
Loading...
