Cisco SG500X-24 - Page 104

Administration: General Information
System Information
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3 86
6
• Firmware MD5 Checksum (Active Image)—MD5 checksum of the active
image.
• Firmware Version (Non-active Image)—Firmware version number of the
non-active image. If the system is in stack mode, the version of the master
unit is displayed.
• Firmware MD5 Checksum (Non-active Image)—MD5 checksum of the
non-active image.
• Boot Version—Boot version number.
• Boot MD5 Checksum—MD5 checksum of the boot version.
• Locale—Locale of the first language. (This is always English.)
• Language Version—Language package version of the first or English
language.
• Language MD5 Checksum—MD5 checksum of the language file.
TCP/UDP Services Status:
• HTTP Service—Displays whether HTTP is enabled/disabled.
• HTTPS Service—Displays whether HTTPS is enabled/disabled.
• SNMP Service—Displays whether SNMP is enabled/disabled.
• Telnet Ser vice—Displays whether Telnet is enabled/disabled.
• SSH Service—Displays whether SSH is enabled/disabled.
PoE Power Information on Master Unit:
• Maximum Available PoE Power (W)—Maximum available power that can
be delivered by the PoE.
• Total PoE Power Consumption (W)—Total PoE power delivered to
connected PoE devices.
• PoE Power Mode—Port Limit or Class Limit.
There is a
Detail link next to PoE Power Information on Master Unit that, when
selected, takes you directly to the Port Management > PoE > Properties page. This
page shows the PoE power information on a per-unit basis.
The units in the stack are displayed graphically, along with the following
information for each unit: