10 Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
Returning the Cisco Small
Business AP541N to the
Factory Default Settings
To use the Reset button to reboot or reset the access point, do the
following:
•To reboot the access point, press the Reset button for less than 10
seconds.
• To restore the access point to the factory default settings:
1. Disconnect the access point from the network or disable all DHCP
servers on your network.
2. With the power on, press-and-hold the Reset button for more than
10 seconds.
Installing the Cisco AP541N
The access point can be placed on a wall, a flat surface, or a ceiling. A
ceiling mount kit is available for this device (AP540N-CMK). Do not deploy
the device in a location where any of the following conditions exist:
High Ambient Temperature—The ambient temperature must not
exceed 104 degrees Fahrenheit (40C).
Reduced Air Flow—The air flow must be adequate to prevent
overheating.
Mechanical Overloading—The device should be level, stable, and
secure to avoid it sliding or shifting out of position.
Circuit Overloading—Adding the device to the power outlet or a PoE
port must not overload that circuit or PoE device.
NOTE We recommend using Cat5e or better cable. Also, do not
exceed the maximum cabling distance of 328 feet (100 meters).
To Next Page
Loading...
