© 2016 Genusys Inc. All rights reserved| gTalk PBX, www.gtalkpbx.com | Support: (214) 593-1004 Page 3
recipient. On the other hand selection (pressing) of ‘green’ line button next to the 10 digit number will
display that number to the call recipient
Ending a Call
To end a call:
• If you are using the handset, just hang up.
• If you are using the speakerphone, press the Speaker button.
• If you are using a headset, either press the Headset button (wired) or replace the receiver (when using
certain wireless models).
Ignoring an Incoming Call:
• When call lands press ‘Ignore’ soft-key button.
Transferring a Call
You can perform following types of transfers:
Performing an Attended Transfer
• Attended Transfer:
- transfer the call while the phone is ringing.
- wait for the person to answer before transferring the call.
STEP 1 - During an active call, press ‘xfer’ soft-key. The call is placed on hold and a new line is opened to
dial the number where the call in intended to be transferred.
STEP 2 Either:
• Enter the number to which you want to transfer the call, then press the ‘dial’ soft-key or wait a few
seconds.
• Press the ‘dir’ soft-key and either choose a number from the personal directory or select the
Corporate Directory, then press the ‘dial’ soft-key.
STEP 3 - Press the ‘xfer’ soft-key after the phone begins to ring, or at any time after the phone is
answered.
Performing an Unattended (Blind) Transfer
To Next Page
Loading...
Need help?
General
