Cisco SPA1112 - Page 101

Voice Parameters
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 101
6
<Display_Name_1_> through <Display_
Name_13_>
Display name for caller ID.
Default setting: blank
<User_ID_1_> through <User_ID_13_> User ID for this line.
Default setting: blank
<Password_1_> through <Password_
13_>
Password for this line.
Default setting: blank
<Use_Auth_ID_1_> through <Use_Auth_
ID_13_>
To use the authentication ID and password for SIP
authentication, select yes. Otherwise, select no to use the
user ID and password.
Default setting: no
<Auth_ID_1_> through <Auth_ID_13_> Authentication ID for SIP authentication.
Default setting: blank
<Resident_Online_Number_1_> through
<Resident_Online_Number_13_>
This setting allows you to associate a "local" telephone
number with this line using a valid Skype Online Number from
Skype. Calls made to that number will ring your phone. Enter
the number without spaces or special characters.
Default setting: blank
SIP URI The SIP URI, in the following format: sip:<username>@<WAN_
IP>:<port> or sip:<username>@<domain>:<port>
<Call_Waiting_Serv_1_>
<Call_Waiting_Serv_2_>
<Call_Waiting_Serv_5_> through <Call_
Waiting_Serv_13_>
Enable Call Waiting Service.
Default setting: yes
<Block_CID_Serv_1_>
<Block_CID_Serv_2_>
<Block_CID_Serv_5_> through <Block_
CID_Serv_13_>
Enable Block Caller ID Service.
Default setting: yes
<Block_ANC_Serv_1_>
<Block,_ANC_Serv_2_>
<Block,_ANC_Serv_5_> through
<Block_ANC_Serv_13_>
Enable Block Anonymous Calls Service
Default setting: yes