Cisco SPA1112 - Page 102

Voice Parameters
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 102
6
<Dist_Ring_Serv_1_>
<Dist_Ring_Serv_2_>
<Block_ANC_Serv_5_> through <Block_
ANC_Serv_13_>
Enable Distinctive Ringing Service
Default setting: yes
<Cfwd_All_Serv_1_>
<Cfwd_All_Serv_2_>
<Cfwd_All_Serv_5_> through <Cfwd_
All_Serv_14_>
Enable Call Forward All Service
Default setting: yes
<Cfwd_Busy_Serv_1_>
<Cfwd_Busy_Serv_2_>
<Cfwd_Busy_Serv_5_> through <Cfwd_
Busy_Serv_13_>
Enable Call Forward Busy Service
Default setting: yes
<Cfwd_No_Ans_Serv_1_>
<Cfwd_No_Ans_Serv_2_>
<Cfwd_No_Ans_Serv_5_> through
<Cfwd_No_Ans_Serv_13_>
Enable Call Forward No Answer Service
Default setting: yes
<Cfwd_Sel_Serv_1_>
<Cfwd_Sel_Serv_2_>
<Cfwd_Sel_Serv_5_> through <Cfwd_
Sel_Serv_13_>
Enable Call Forward Selective Service.
Default setting: yes
<Cfwd_Last_Serv_1_>
<Cfwd_Last_Serv_2_>
<Cfwd_Last_Serv_5_> through <Cfwd_
Last_Serv_13_>
Enable Forward Last Call Service
Default setting: yes
<Block_Last_Serv_1_>
<Block_Last_Serv_2_>
<Block_Last_Serv_5_> through <Block_
Last_Serv_13_>
Enable Block Last Call Service
Default setting: yes
<Accept_Last_Serv_1_>
<Accept_Last_Serv_2_>
<Accept_Last_Serv_5_> through
<Accept_Last_Serv_13_>
Enable Accept Last Call Service
Default setting: yes