Cisco SPA1112 - Page 110

Voice Parameters
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 110
6
<Auto_PSTN_Fallback_1_>
<Auto_PSTN_Fallback_2_>
<Auto_PSTN_Fallback_5_> through
<Auto_PSTN_Fallback_13_>
If enabled, the ATA automatically routes all calls to the PSTN
gateway when the SIP proxy is down (registration failure or
network link down).
Default setting: yes
<Cfwd_No_Ans_Dest_1_>
<Cfwd_No_Ans_Dest_2_>
<Cfwd_No_Ans_Dest_5_> through
<Cfwd_No_Ans_Dest_13_>
Forward number for Call Forward No Answer Service. Same
as Cfwd All Dest.
Default setting: blank
<Cfwd_No_Ans_Delay_1_>
<Cfwd_No_Ans_Delay_2_>
<Cfwd_No_Ans_Delay_5_> through
<Cfwd_No_Ans_Delay_13_>
Delay in sec before Call Forward No Answer triggers. Same
as Cfwd All Dest.
Default setting: 20
<Idle_Polarity_1_>
<Idle_Polarity_2_>
Polarity before a call is connected: Forward or Reverse.
Default setting: Forward
<Caller_Conn_Polarity_1_>
<Caller_Conn_Polarity_2_>
Polarity after an outbound call is connected: Forward or
Reverse.
Default setting: Forward.
<Callee_Conn_Polarity_1_>
<Callee_Conn_Polarity_2_>
Polarity after an inbound call is connected: Forward or
Reverse.
Default setting: Forward
<Cfwd_All_Dest_1_>
<Cfwd_All_Dest_2_>
<Cfwd_All_Dest_5_> through <Cfwd_
All_Dest_13_>
Forward number for Call Forward All Service.
Default setting: blank
<Cfwd_Busy_Dest_1_>
<Cfwd_Busy_Dest_2_>
<Cfwd_Busy_Dest_5_> through <Cfwd_
Busy_Dest_13_>
Forward number for Call Forward Busy Service. Same as
Cfwd All Dest.
Default setting: blank