Cisco SPA1112 - Page 111

Voice Parameters
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 111
6
<Cfwd_Sel1_Caller_1_> through
<Cfwd_Sel8_Caller_1_>
<Cfwd_Sel1_Caller_2_> through
<Cfwd_Sel8_Caller_2_>
Caller number pattern to trigger Call Forward Selective
service. When the caller’s phone number matches the entry,
the call is forwarded to the corresponding Cfwd Selective
Destination (Cfwd Sel1-8 Dest).
• Use ? to match any single digit.
• Use * to match any number of digits.
Example: 1408*, 1512???1234
In the above example, a call is forwarded to the
corresponding destination if the caller ID either starts with
1408 or is an 11-digit numbering starting with 1512 and
ending with 1234.
Default setting: blank
<Cfwd_Sel1_Dest_1_> through <Cfwd_
Sel8_Dest_1_>
<Cfwd_Sel1_Dest_2_> through <Cfwd_
Sel8_Dest_2_>
The destination for the corresponding Call Forward Selective
caller pattern (Cfwd Sel1-8 Caller).
Default setting: blank
<FAX_CNG_Detect_Enable_1_>
<Cfwd_Last_Caller_1_>
<Cfwd_Last_Caller_2_>
The number of the last caller; this caller is actively forwarded
to the Cfwd Last Dest via the Call Forward Last service.
Default setting: blank
<Cfwd_Last_Dest_1_>
<Cfwd_Last_Dest_2_>
The destination for the Cfwd Last Caller.
<Block_Last_Caller_1_>
<Block_Last_Caller_2_>
The number of the last caller; this caller is blocked via the
Block Last Caller Service.
Default setting: blank
<Accept_Last_Caller_1_>
<Accept_Last_Caller_2_>
The number of the last caller; this caller is accepted via the
Accept Last Caller Service.
Default setting: blank