Cisco SPA1112 - Page 137

Voice Parameters
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 137
6
<CW_Per_Call_Act_Code> Enables call waiting for the next call.
Default setting: *71
<CW_Per_Call_Deact_Code> Disables call waiting for the next call.
Default setting: *70
<Block_CID_Act_Code> Blocks caller ID on all outbound calls.
Default setting: *67
<Block_CID_Deact_Code> Removes caller ID blocking on all outbound calls.
Default setting: *68
<Block_CID_Per_Call_Act_Code> Blocks caller ID on the next outbound call.
Default setting: *81
<Block_CID_Per_Call_Deact_Code> Removes caller ID blocking on the next inbound call.
Default setting: *82
<Block_ANC_Act_Code> Blocks all anonymous calls.
Default setting: *77
<Block_ANC_Deact_Code> Removes blocking of all anonymous calls.
Default setting: *87
<DND_Act_Code> Enables the do not disturb feature.
Default setting: *78
<DND_Deact_Code> Disables the do not disturb feature.
Default setting: *79
<CID_Act_Code> Enables caller ID generation.
Default setting: *65
<CID_Deact_Code> Disables caller ID generation.
Default setting: *85
<CWCID_Act_Code> Enables call waiting, caller ID generation.
Default setting: *25
<CWCID_Deact_Code> Disables call waiting, caller ID generation.
Default setting: *45
<Dist_Ring_Act_Code> Enables the distinctive ringing feature.
Default setting: *26
<Dist_Ring_Deact_Code> Disables the distinctive ringing feature.
Default setting: *46