Cisco SPA1112 - Page 138

Voice Parameters
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 138
6
<Speed_Dial_Act_Code> Assigns a speed dial number.
Default setting: *74
<Paging_Code> Used for paging other clients in the group.
Default setting: *96
<Secure_All_Call_Act_Code> Makes all outbound calls secure.
Default setting: *16
<Secure_No_Call_Act_Code> Makes all outbound calls not secure.
Default setting: *17
<Secure_One_Call_Act_Code> Makes the next outbound call secure. (It is redundant if all
outbound calls are secure by default.)
Default setting: *18
<Secure_One_Call_Deact_Code> Makes the next outbound call not secure. (It is redundant if all
outbound calls are not secure by default.)
Default setting: *19
<Conference_Act_Code> If this code is specified, the user must enter it before dialing
the third party for a conference call. Enter the code for a
conference call.
Default setting: blank
<Attn-Xfer_Act_Code> If the code is specified, the user must enter it before dialing
the third party for a call transfer. Enter the code for a call
transfer.
Default setting: blank
<Modem_Line_Toggle_Code> Toggles the line to a modem. Modem passthrough mode can
be triggered only by pre-dialing this code.
Default setting: *99
<FAX_Line_Toggle_Code> Toggles the line to a fax machine.
Default setting: #99
<Media_Loopback_Code> Use for media loopback.
Default setting: *03