Cisco SPA1112 - Page 153

Router Configuration Parameters
<WAN_Interface> WAN Interface Parameters
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 153
7
WAN Example 1: DHCP with automatic MTU mode
<router-configuration>
<WAN_Interface>
<WAN_Connection_Type>dh</WAN_Connection_Type>
<WAN_DHCP_MTU_Mode>0</WAN_DHCP_MTU_Mode>
<WAN_DHCP_MTU_Size>0</WAN_DHCP_MTU_Size>
<WAN_Static_IP_NET>0.0.0.0:0.0.0.0:0.0.0.0</WAN_Static_IP_NET>
<WAN_Static_MTU_Mode>0</WAN_Static_MTU_Mode>
<WAN_Static_MTU_Size>0</WAN_Static_MTU_Size>
<WAN_PPPoE_User_Name />
<WAN_PPPoE_Service_Name />
<WAN_PPPoE_Password />
<WAN_PPPoE_Keep_Alive>0:0:30</WAN_PPPoE_Keep_Alive>
<WAN_PPPoE_MTU_Mode>0</WAN_PPPoE_MTU_Mode>
<WAN_PPPoE_MTU_Size>0</WAN_PPPoE_MTU_Size>
</WAN_Interface>
...
</router-configuration>
<WAN_PPPoE_Keep_Alive> User Interface: Interface Setup > Basic Setup > Internet Settings
page, Keep Alive field and Connect on Demand field (available when
PPPoE is the Connection Type)
Description: Keep Alive or Connect on Demand settings for a PPPoE
session configured.
Parameter: Type:Max_Idle_Time:30
Values:
0 (Keep Alive)
0 (Connect on Demand)
Max_Idle_Time (Minutes)=1...9999 (for Connect on Demand)
30 is a static value
Default: 0:0:30
Example:
<WAN_PPPoE_Keep_Alive>1:5:30</WAN_PPPoE_Keep_Alive>
Parameter Details