Configuring the Voice Settings
Regional
Cisco SPA100Series Administration Guide 74
4
Control Timer Values (sec)
Ring Voltage Ringing voltage. Choices are 60–90 (V)
Default setting: 85
CWT Frequency Frequency script of the call waiting tone. All distinctive
CWTs are based on this tone.
Default setting: 440@-10
Synchronized Ring If this is set to yes, when the ATA is called, all lines ring at
the same time (similar to a regular PSTN line) After one line
answers, the others stop ringing.
Default setting: no
Field Description
Hook Flash Timer
Min
Minimum on-hook time before off-hook qualifies as hook
flash. Less than this the on-hook event is ignored. Range:
0.1–0.4 seconds.
Default setting: 0.1
Hook Flash Timer
Max
Maximum on-hook time before off-hook qualifies as hook
flash. More than this the on-hook event is treated as on
hook (no hook-flash event) Range: 0.4–1.6 seconds.
Default setting: 0.9
Callee On Hook
Delay
Phone must be on-hook for at this time in sec. before the
ATA will tear down the current inbound call. It does not
apply to outbound calls. Range: 0–255 seconds.
Default setting: 0
Reorder Delay Delay after far end hangs up before reorder tone is played.
0 = plays immediately, inf = never plays. Range: 0–255
seconds.
Default setting: 5.
Call Back Expires Expiration time in seconds of a call back activation. Range:
0–65535 seconds.
Default setting: 1800
Call Back Retry
Intvl
Call back retry interval in seconds. Range: 0–255
seconds.
Default setting: 30
Field Description
To Next Page
Loading...
Need help?
General
Weight and Dimensions
