Configuring the Voice Settings
Regional
Cisco SPA100Series Administration Guide 76
4
Vertical Service Activation Codes
Vertical Service Activation Codes are automatically appended to the dial-plan.
There is no need to include them in dial-plan, although no harm is done if they are
inclu`ded.
CPC Duration Duration in seconds for which the tip-to-ring voltage is
removed after the caller hangs up. After that, tip-to-ring
voltage is restored and the dial tone applies if the
attached equipment is still off-hook. CPC is disabled if this
value is set to 0. Range: 0 to 1.000 second. Resolution is
0.001 second.
Default setting: 0 (CPC disabled)
Field Description
Call Return Code Call Return Code This code calls the last caller.
Default setting: *69
Call Redial Code Redials the last number called.
Default setting: *07
Blind Transfer
Code
Begins a blind transfer of the current call to the extension
specified after the activation code.
Default setting: *98
Call Back Act
Code
Starts a callback when the last outbound call is not busy.
Default setting: *66
Call Back Deact
Code
Cancels a callback.
Default setting: *86
Call Back Busy Act
Code
Starts a callback when the last outbound call is busy.
Default setting: *05
Cfwd All Act Code Forwards all calls to the extension specified after the
activation code.
Default setting: *72
Cfwd All Deact
Code
Cancels call forwarding of all calls.
Default setting: *73
Field Description
To Next Page
Loading...
Need help?
General
Weight and Dimensions
