Cisco UCS C210 M2 - Cisco Security Manager License

8
Cisco Security Manager 4.3 UCS Server Bundles Quick Start Guide
78-21007-01
Updates and Service Packs for the UCS Server
Updates and Service Packs for the UCS Server
Cisco periodically releases updates and service packs for its UCS servers. As the administrator of the
Cisco UCS Server which forms part of this Bundle, you are responsible for the necessary updates and
service packs, which you can obtain by visiting http://www.cisco.com/go/ucs. You can also use the
following hyperlink, which is the direct URL:
• Cisco UCS C220 M3 Rack Server Software:
http://www.cisco.com/cisco/software/type.html?mdfid=284296253&i=rs
Cisco Security Manager License
Caution Your Cisco Security Manager license is provided in paper format and is packed in your shipping carton
along with your new Bundle itself. Please take care that it is not inadvertently discarded or lost.
This Bundle includes the following license support:
• The low-end hardware configuration (16 GB RAM, 4 x 500 GB HDD) provides support for 50
devices.
Note Cisco does not recommend (1) attempting to expand the capabilities of the low-end hardware
configuration (16 GB RAM, 4 x 500 GB HDD) by adding licenses or (2) otherwise attempting to change
the license configuration; the Bundle was tested as shipped.
• The high-end hardware configuration (24 GB RAM, 7 x 500 GB HDD) provides support for 150
devices.
Note Cisco does not recommend (1) attempting to expand the capabilities of the high-end hardware
configuration (24 GB RAM, 7 x 500 GB HDD) by adding licenses or (2) otherwise attempting to change
the license configuration; the Bundle was tested as shipped.
Note Evaluation licenses are not available for this Bundle.
IP Address and Hostname
Assigning an IP Address
During deployment of your new Bundle at your site, you must assign the server a static IP address.
(Security Manager requires one IP address. It must be a static IP address; dynamic IP addresses are not
supported.)
To assign the server a static IP address, first obtain a static IP address from your network administrator
and then follow the procedures for IP address assignment published by Microsoft for Windows Server
2008.