Enter the following commands:
Server# scope cimc
Server/cimc # scope firmware
Server/cimc/firmware # show detail
Firmware Image Information:
Update Stage: NONE
Update Progress: 0%
Current FW Version: 2.3(1.20140818121921)
FW Image 1 Version: 2.3(1.20140818121921)
FW Image 1 State: RUNNING ACTIVATED
FW Image 2 Version: 2.3(1.20140818113904)
FW Image 2 State: BACKUP INACTIVATED
Boot-loader Version: 2.3(1.20140818121921).33
CPLD Version: 0.62
Hardware Version: 0
Determining the LSI Firmware Version—Applicable on CIMC Release 1.
x
To determine the LSI firmware version, do the following from the CIMC GUI.
Procedure
SUMMARY STEPS
1.
In the Navigation pane, click the Server tab.
2.
On the Server tab, click Inventory. The Inventory page appears.
3.
Click the Storage tab.
4.
In the Storage Adapters area, the LSI firmware information is displayed in the Firmware Package Build
column.
DETAILED STEPS
Step 1
In the Navigation pane, click the Server tab.
Step 2
On the Server tab, click Inventory. The Inventory page appears.
Step 3
Click the Storage tab.
Step 4
In the Storage Adapters area, the LSI firmware information is displayed in the Firmware Package Build column.
Determining the LSI Firmware Version—Applicable on CIMC Release 2.
x
This procedure is applicable to E-Series Servers and the SM E-Series NCE. This section is not applicable
to the EHWIC E-Series NCE.
Note
To determine the LSI firmware version, do the following from the CIMC GUI.
Procedure
Troubleshooting Guide for Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine
11
Overview
Determining Version Information
To Next Page
Loading...
