Cisco WAP371 Wireless Access Point 2
Cisco WAP371 Wireless-AC/N Dual Radio
Access Point with Single Point Setup
Features
Front Panel
The front panel of the device consists of three lights: Power, WLAN, and
LAN. For full descriptions of the colors of the lights and their indications,
see Verifying the Hardware Installation, page 6.
A Kensington lock slot is found under the lights.
Back Panel
The back panel of the device has an RJ-45 Ethernet port. Use the Ethernet
port to power your device using PoE. It is an auto-sensing, Gigabit
Ethernet (802.3) port used to connect your WAP devices to network
devices, such as computers, routers, or switches. We strongly
recommend that you use a Category 5e or better cable for gigabit
connectivity.
The 12V DC jack is used to connect the supplied power adapter to the
Cisco WAP371 if you are not using PoE.
The back panel of the device has a Reset button. See Rebooting the
Devices or Returning them to their Factory Default Settings, page 10
for information on the Reset button.
Default SettingHAF1H39Cs
If you are using a Cisco RV Series router, the default range for the DHCP
assigned address is from 192.168.1.100 to 192.168.1.254. Any device
connecting to the same LAN will be assigned an IP address in this range.
Parameter Default Value
Username cisco
Password cisco
LAN IP Address DHCP address assigned
by server
Fallback LAN IP 192.168.1.245
Subnetwork Mask 255.255.255.0
To Next Page
Loading...
