Cisco WBPN User Manual

Using the WBPN Wireless-N Bridge for Phone Adapters Configuration Utility
Viewing Status Information
Cisco WBPN User Guide 21
2
When you finish making changes on a configuration page, click Apply (labeled #3
in Figure1) to save the changes. Click Reset (labeled #4 in Figure1), Clear, or
Cancel to undo your changes.
Viewing Status Information
The WBPN provides information about its status, including system information and
statistics.
System Information
The following system information is provided:
Wired Network Information
The following wired network information is provided:
Firmware Version Firmware version that is installed on the WBPN.
Build Time Date and time that the firmware was built.
Serial Number Unique serial number of the WBPN unit.
HW_Rev Hardware version number.
PID VID Product ID and version identifier of the WBPN.
IP Address IP address of the WBPN.
Subnet Mask Subnet mask of the WBPN IP address.
Default Gateway The node that the network software uses when an IP
address does not match any other routes in the routing
table.
MAC Address Hardware address of the wired (Ethernet) interface on
the WBPN.
Send Packets Packets that have been transmitted over the Ethernet
interface from the WBPN to the network.

Cisco WBPN Specifications

General

Brand	Cisco
Model	WBPN
Category	Network Hardware
Language	English