Index
IN-10
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
78-6511-08
Front Panel view 2-2
cluster tree 2-5
command switch 2-4
described 2-4
pop-up menus 2-24
port icons 2-6
port LEDs 2-8
RPS LED 2-7
switch images 2-6
FTP, accessing MIB files 4-5
G
GBIC_1000BASET system messages A-15
GBIC modules
1000BASE-LX/LH
1-10
1000BASE-SX 1-9
1000BASE-T 1-9
1000BASE-ZX 1-10
CWDM 1-21
GigaStack 1-9
troubleshooting 9-8
GBIC security messages A-16
get-next-request operation 4-6
get-request operation 4-6
get-response operation 4-6
Gigabit Ethernet
clusters, illustrated
6-35
ports, configuring flow control on 7-3
port settings 7-2
settings 7-2
trunks 8-26
Gigabit Interface Converter
See GBIC modules
GigaStack system messages
A-17
global configuration mode 3-3
graphs, bandwidth 2-8
guide mode 1-7, 2-28
H
hardware memory system messages
See HW_MEMORY system messages
HC (candidate switch)
5-23
hello BPDU interval 6-43
hello time
changing
6-43
defined 6-42
help, CLI 3-5
Help button, CMS 2-31
Help Contents 2-29
history group, in RMON 4-5
hold-time, modifying 6-22
hops, configuring 6-14
host name list, CMS 2-30
host names
abbreviations appended to
5-23
in clusters 5-16
to address mappings 6-6
hosts, limit on dynamic ports 8-42
HP OpenView 1-6
HSRP
automatic cluster recovery
5-15
cluster standby group considerations 5-13
recovering from command switch failure 9-18
See also clusters, cluster standby group, and standby
command switch
hsrp traps
6-49
HTTP access 2-32, 4-3
HW_MEMORY system messages A-18
Hypertext Transfer Protocol
See HTTP access
To Next Page
Loading...
Need help?
General