EasyManua.ls Logo

Cissell L28US30G - User Manual

Cissell L28US30G
64 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Page 1
MAN2030 (ECN5752) 8/99 IH
MODELS
GAS STEAM ELECTRIC
L28US30G L28UR30S L28UR30E
L28UR30G
OWNER'S MANUAL
30 Lb. Laundry Dryer
THIS MANUAL MUST BE GIVEN TO THE EQUIPMENT OWNER.THIS MANUAL MUST BE GIVEN TO THE EQUIPMENT OWNER.
THIS MANUAL MUST BE GIVEN TO THE EQUIPMENT OWNER.THIS MANUAL MUST BE GIVEN TO THE EQUIPMENT OWNER.
THIS MANUAL MUST BE GIVEN TO THE EQUIPMENT OWNER.
CISSELL MANUFACTURING COMPANY
HEADQUARTERS PHONE: (502) 587-1292
831 SOUTH FIRST ST. SALES FAX: (502) 585-3625
P.O. BOX 32270 SERVICE/PARTS FAX: (502) 681-1275
LOUISVILLE, KY 40232-2270

Table of Contents

Questions and Answers

  • J
    Jennifer LawrenceAug 19, 2025
    Why is the motor tripping on thermal in my Cissell L28US30G Dryer?
    • M
      Michele SmithAug 19, 2025
      If the motor in your Cissell Dryer keeps tripping on thermal, consider the following: 1. **Low Voltage:** Check the voltage at the motor terminals. It should be within +10% of what's listed on the motor rating plate. If it's not, contact your local power company for advice. 2. **Inadequate Wiring:** Consult with your local power company to ensure the wiring is adequately sized for the load. 3. **Loose Connections:** Inspect all electrical connections and tighten any that are loose. 4. **Inadequate Air:** Refer to the installation sheet for recommended make-up air openings. 5. **Poor Housekeeping:** Clean any lint accumulation on and around the motors.
  • R
    Ronald ThomasAug 27, 2025
    What to do if motor runs but basket will not revolve in Cissell Dryer?
    • T
      Tammy Kennedy DDSAug 27, 2025
      If the motor of your Cissell Dryer runs but the basket won't revolve, it could be due to a few reasons: * The V-belt might be broken and needs replacement. * The V-belt could be loose and needs adjustment. * The motor pulley might be loose, requiring you to tighten the set screw. * The basket might be overloaded; try removing some of the load.
  • B
    Bradley RogersSep 2, 2025
    How to fix a Cissell L28US30G that does not stop at end of time period?
    • K
      Kelly NicholsSep 2, 2025
      If your Cissell Dryer doesn't stop at the end of the time period, the timer is likely defective and needs to be replaced.
  • J
    josephpowersNov 10, 2025
    What to do if the motor will not start in my Cissell L28US30G Dryer?
    • C
      Christopher HodgesNov 10, 2025
      If the motor of your Cissell Dryer won't start, here are a few things to check: * First, ensure the dryer is getting power by checking the fuses and circuit breakers. Also, make sure the main control switch is in the “on” position. If it's a gas dryer, check the bonnet thermostat. * Verify the power source matches the electrical rating plate of the dryer in terms of voltage, phase, and frequency. * Confirm the timer is set correctly or that the coin meter has properly vended. * Inspect the wire connections in the electrical box on the rear of the dryer for any looseness. * Make sure the loading door is fully closed. * Check and adjust the door switch by bending the actuator lever to ensure it clears the switch button by 3/8" when the front panel is in place. If the door switch...

Cissell L28US30G Specifications

General IconGeneral
BrandCissell
ModelL28US30G
CategoryDryer
LanguageEnglish

Related product manuals