EasyManua.ls Logo

Cissell L50CD42G - User Manual

Cissell L50CD42G
67 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Page 1
OWNER'S MANUAL
150 Lb. Laundry Dryer
MODELS
GAS STEAM
L50CD42G L50CD42S
C150G C150S
MAN2150 9/99 5C MPC
THIS MANUAL MUST BE GIVEN TO THE EQUIPMENT OWNER.
CISSELL MANUFACTURING COMPANY
HEADQUARTERS PHONE: (502) 587-1292
831 SOUTH FIRST ST. SALES FAX: (502) 585-3625
P.O. BOX 32270 SERVICE/PARTS FAX: (502) 681-1275
LOUISVILLE, KY 40232-2270
Member of:

Table of Contents

Questions and Answers

  • V
    Vicki LyonsAug 21, 2025
    Why won't the motors start on my Cissell Dryer?
    • W
      Wendy HallAug 21, 2025
      If the motors on your Cissell Dryer won't start, consider these potential causes: * No power: Check the fuses or circuit breakers and ensure the main control switch is turned ON. * Incorrect power: Verify the power source matches the electrical rating plate for voltage, phase, and frequency. * Timer is off: Turn the timer clockwise to the desired time setting. * Loose wiring connections: Inspect the wire connections in the electrical box on the rear of the dryer. * Defective starting relay: Check the coils and contacts. * Motor internal overloads tripped (MTR30X series only): Reset the internal overloads by pressing the button on the motor body.
  • J
    James EvansAug 23, 2025
    What to do if my Cissell Dryer is too hot?
    • G
      Gilbert KingAug 23, 2025
      If your Cissell Dryer is overheating, consider the following potential causes and solutions: * Incorrect main burner orifices: Replace orifices -- check factory for correct size. * Inadequate make-up air: Ensure make-up air is 4 to 6 times the exhaust area of the dryer. * Lint accumulation: Remove lint. * Exhaust duct dampers: Ensure dampers are fully open, or replace them. * Gas pressure too high: Adjust gas pressure as specified on rating plate. * Partially restricted or inadequately sized exhaust system: Check installation sheet in service section for recommended sizes. Check for and remove obstructions or lint build-up from duct work. Never use smaller size exhaust duct. Always use larger size exhaust duct. * Defective thermostat: Replace thermostat.
  • Z
    zjordanAug 26, 2025
    Why is my Cissell Dryer motor tripping on thermal overload?
    • W
      Wesley WilliamsAug 26, 2025
      If the motor of your Cissell Dryer is tripping on thermal overload, here are a few possible reasons: * Low voltage: Check the voltage at the motor terminals. It must be within 10% of the voltage on the motor rating plate. If not, contact your local power company. * Inadequate wiring: Contact your local power company to ensure the wiring is adequately sized for the load. * Loose connections: Check all electrical connections and tighten any loose connections. * Inadequate air: Check installation sheet in service section for recommended make-up air openings. * Poor housekeeping: Clean lint accumulation on and around motors.
  • L
    Lindsay JacobsAug 28, 2025
    What causes the main burners to burn improperly on a Cissell Dryer?
    • E
      Erica FernandezAug 28, 2025
      Improper burning of the main burners in your Cissell Dryer can be due to: * Burner air shutters closed: Open for blue flame. * Dirt in burner: Blow out. * Gas pressure too high: Check rating plate for correct gas pressure. * Orifice too large: Send to factory for correct orifices. * Restricted or blocked exhaust: Clean exhaust.
  • T
    Tina LewisAug 30, 2025
    Why is my Cissell Dryer noisy or vibrating?
    • J
      Joshua SharpAug 30, 2025
      If your Cissell Dryer is making excessive noise or vibrating, here are some potential causes: * Not leveled: Check manual for proper leveling procedures. * Fan out of balance: Accidental damage to the fan blade can change the dynamic balance. Damaged fans should be replaced. * Basket rubbing: Adjust basket clearance. * V-Belt sheaves: Tighten Set Screws, make sure sheaves are in proper alignment. * Belt: Adjust belt tension. * Foreign objects: Occasionally screws, nails, etc., will hang in the basket perforations and drag against the sweep sheets surrounding the basket. Such foreign objects should be removed immediately.
  • B
    Brent WoodsSep 2, 2025
    What to do if my Cissell Dryer basket motor will not run?
    • P
      Peggy MoonSep 2, 2025
      If the basket motor of your Cissell Dryer isn't running, try the following: * Loading door open: Close door. * Door switch out of adjustment: Adjust switch by removing cover and bend actuator lever to clear switch button 3/8” (10 mm) with cover in place. * Defective door switch: Replace switch. * Defective basket motor contactor: Replace contactor.
  • B
    Bradley HunterSep 4, 2025
    Why is there low or high gas flame in my Cissell Dryer?
    • C
      Charles WilliamsonSep 4, 2025
      A low or high gas flame in your Cissell Dryer may be caused by incorrect main burner orifices. Replace orifices -- check factory for correct size.
  • C
    Christopher SampsonSep 6, 2025
    What to do if my Cissell Dryer basket motor runs, but the basket will not revolve?
    • M
      Madison ChandlerSep 6, 2025
      If the basket motor in your Cissell Dryer is running, but the basket isn't revolving, consider these possibilities: * V-Belt broken: Replace V-Belt. * V-Belt loose: Adjust belt tension. * Motor Pulley loose: Tighten Set Screw. * Basket overloaded: Remove load.
  • T
    Thomas PhillipsSep 8, 2025
    What to do if my Cissell Dryer runs, but there is no steam to the coils?
    • P
      Paula MooreSep 8, 2025
      If your Cissell Dryer runs but no steam reaches the coils, consider these solutions: * Valve closed: Check all valves in steam supply and return -- make sure they are open. * Steam trap blocked: Remove and clean. Replace if defective. * Solenoid valve: On dryers using solenoid temperature control, check operation of solenoid valve by advancing thermostat. * Thermostat: On dryers using solenoid temperature control, thermostat controls operation of solenoid valve. If defective, replace thermostat. * Check valve installed incorrectly: Check for inlet and outlet marking on check valve, and invert if necessary. * Strainer clogged: Remove plug and blow down strainer or remove and clean thoroughly if heavily clogged.
  • K
    Kevin Rivas Jr.Sep 12, 2025
    What causes water in the steam line of my Cissell Dryer?
    • A
      Alejandra FletcherSep 12, 2025
      If you find water in the steam line of your Cissell Dryer, here are possible causes: * Steam piping installed incorrectly: Check piping per steam installation instructions. * Trap not functioning: Check trap for size and capacity. If dirty and sluggish, clean thoroughly or replace. Check return line for high back pressure, or another trap charging against the trap functioning improperly.

Summary

Product Models

Important Safety Notices

Gas Leak Safety Procedures

Critical steps for responding to gas leaks to ensure operator safety.

General Operational Safety Warnings

Key safety precautions for operating and maintaining the dryer.

Cissell Dryer Warranty Information

Identification Nameplate Location

Details the location and purpose of the dryer's identification nameplate.

Understanding Dryer Symbols

Unpacking and General Installation

Dryer Unpacking and Initial Setup

Procedures for unpacking the dryer and preparing for installation.

General Installation Requirements

Guidelines for proper dryer placement, leveling, and clearance.

Installation and Maintenance Basics

Replacement Parts and Procedures

Information on obtaining and disassembling parts for the dryer.

Gas Fired Dryer Dimensions

150 lb. Dryer Specifications

General Dryer Specifications

Key technical specifications including dimensions, capacity, and performance metrics.

Gas Pipe Sizing Chart

Gas Piping Installation Guidelines

Steam Heated Dryer Dimensions

150 lb. Steam Dryer Specifications

Steam Dryer Technical Data

Detailed specifications for steam heated dryers, including coils and connections.

Motor Specifications for Steam Dryers

Information on the motors used in steam heated dryers.

Electrical Connections and Grounding

Dryer Electrical Grounding Instructions

Essential steps for safely grounding the dryer to prevent electrical hazards.

Steam Dryer Installation Instructions

Steam Piping Installation

Steam Piping Recommendations

Best practices for steam piping to ensure proper circulation and safety.

Dryer Installation with Multiple Exhaust

Multiple Exhaust System Requirements

Guidelines for installing dryers that share a common exhaust system.

Dryer Installation with Separate Exhaust

Separate Exhaust System Guidelines

Recommendations for dryers requiring individual exhaust venting.

Exhaust and Venting Best Practices

Dryer Air Flow and Venting

Critical information on maintaining optimal airflow and venting for dryer performance.

Rules for Safe Dryer Operation

Safe Operation and Energy Saving Tips

Energy Saving Tips for Dryer Use

Advice on maximizing dryer efficiency and reducing energy costs.

Two Timer Model Operating Instructions

Moisture Control Operating Instructions

Troubleshooting Dryer Issues

Common Dryer Problems and Solutions

A guide to identifying and resolving common dryer malfunctions.

Troubleshooting Chart

Direct Spark Ignition Operation

General Maintenance Procedures

Basket Alignment Instructions

Aligning Dryer Baskets

Step-by-step guide for adjusting dryer baskets for proper operation.

Reversing Control Timer Operations

Adjusting Reversing Timer Dwell Time

Instructions for setting the dwell time for the basket reversing timer.

Fan and Basket Rotation Control

Setting Fan and Basket Rotation

Guidance on configuring fan and basket rotation settings for the dryer.

Front Panel and Door Assembly Parts

Permanent Press Control Panel Assembly

Moisture Control Panel Assembly

Gas Bonnet and Burner Assembly

Reversing Control Panel Assembly (Gas)

Reversing Control Panel Assembly (Steam)

Temperature Assembly Parts

Cissell L50CD42G Specifications

General IconGeneral
ModelL50CD42G
Control TypeMicroprocessor
Drying Capacity50 lb
Width42.125 in
Depth50.25 in
Height77.5 in

Related product manuals