19
English
Using each function (mode)
<Changing the mode during time measurement in chronograph mode>
Even if button
Ⓜ
is pressed during a time measurement in chronograph mode and mode
is changed, time measurement is continued internally. The measured time is shown when
the mode is returned to chronograph again. However, if the time measurement is
continued for more than 24 hours, the chronograph stops at the reset state.
* Confirmation sound and EL light
At the time of start, stop, split time check or reset operation in chronograph mode, a
confirmation sound is heard.
At the time of stop or a split time measurement, the EL light is turned on for 3
seconds with the sound.
Split time: Elapsed time from start point
Split time
Split time
Start point Goal
To Next Page
Loading...
