Citizen CL-E720 - Cut Settings

-11-
6. Cut settings
The auto-cutter-related commands are described below. See the Command
Reference manual for more details.
The following commands set the cut position and number of operations.
Cut-position setup command STX fnnn
This command species the distance between the sensor and the media cut
position.
Media-cut command STX o
This command executes one media-cut operation.
Software-switch setup command STX Vn
z This command temporarily selects the on/o state of the auto cutter or
the peeler, which are normally set in memory.
Examples:
n = 1: The auto cutter is set in the on state
n = 0: The auto cutter is set in the o state
Note
See the Command Reference manual for a detailed description of the
parameter n of the command.
Sheet-cutting interval command cnn (two-digit entry method)
:nnnn (four-digit entry method)
This command instructs the printer to cut the media after a specied number
of sheets have been printed.
Example: To set the sheet-cutting interval to 10 sheets
Two-digit data method
(Other label format commands) (Other label format commands)
Four-digit data method
ST
X L
c10
E
STX L
：0010
E