Citizen CL-S400DT - Page 39

39
Chapter 2 Printer Operation

Zebra® Emulation
Top Menu Sub Menu Default Menu Remarks
Page Setup Print Speed* 6 IPS 2 to 6 IPS Printing speed setting.
Print Darkness 10 00 to 30 Adjusting print darkness.
Darkness Adjust
[Darkness Adj]
00 -10 to 10 Fine adjustment of darkness commands.
Continuous Media
Length
[Cont Media Len]
4.00 inch
101.6 mm
0.25 to 32.00 inch
6.4 to 812.8 mm
Setting media length of continuous media.
Lower level = during mm mode.
Vertical Position
[Vertical Pos]
0.00 inch
0.0 mm
-1.00 to 1.00 inch
-25.4 to 25.4 mm
Adjusting printing start position.
Horizontal Position
[Horizontal Pos]
0.00 inch
0.0 mm
-1.00 to 1.00 inch
-25.4 to 25.4 mm
Adjusting horizontal image position.
Vertical Image Shift
[Vertical Image]
000 dots -120 to 120 dots Adjust the o set value in vertical when
mapping data on a RAM.
Auto Side Shift 00 dots 00 to 15 dots Allows horizontal shifting of printing position
by specied number of dots per page.
Eective when load is applied to a specic
head area, like vertical lines.
Media Sensor See Through See Through
Reect
None
Selecting media sensor.
Small Media
Adjustment
[Small Media Adj]
O On
O
Setting for small media.
Small Media Length
[Small Media Len]
1.00 inch
25.4 mm
0.25 to 1.00 inch
6.4 to 25.4 mm
Setting media length for small media.
Symbol Set PM 50 symbols Setting symbol set.
System Setup
Sensor Monitor – – Displays level of sensor that is currently selected.
Sensor Level 1.7 V 0.0 V to 3.3 V Selects threshold of the sensor.
Paper End Level 2.80 V 0.01 to 3.00 V Sets the paper end level.
Error Reporting
[Error Report]
On Printing
On Printing
Immediate
Setting for error report.
Buzzer Select Exec/Err Exec/Err
All
Error
Key
None
Setting buzzer sounding conditions.
Metric/Inch
[Metric/Inch Sel]
Inch Inch
mm
Sets the units.
Max Media Length
[Max Media Len]
10.00 inch
254.0 mm
1.00 to 50.00 inch
25. 4 to 1270.0 mm
Sets the maximum media length.
Settings Lock O On
O
Prevents a command changing the set value.
Keyboard Lock O On
O
Prevents a change by a key operation.
Hold down the Menu Key for at least 4
seconds to enter the Menu Setup Mode
when setting the “On” menu.
* 2 to 4 IPS with optional peeler.
Mode Settings
[Zebra® Emulation]